Application
• Single Acting, Handed
• Exterior or Interior Doors
• Lead-Lined/Heavy/High Traffic Doors
• Weight to 1500 lbs.*
• Door Width up to 4'0" (1219mm)
Available for the following lead-lined door
thicknesses: 1-3/4"(44mm), 2" (51mm),
2-1/4" (57mm), 2-1/2" (63mm) or 3" (76mm)
• Additional thrust bearing for greater load
capacity
• Built-in positive dead stop prevents door from
swinging beyond the desired opening degree
(specify 85°, 90°, 95° or 105° )
• Separate and independent valves for closing
speed, latch speed and backcheck
• Available non-hold open (N) or selective hold
open (S) at same degree as dead stop
• Delayed action option – prefix “DA”
( non-hold open closers only )
• Models available to meet ICC/ANSI A117.1 low
opening force requirements, prefix “PH”.
( For 8-1/2 lbs. of opening force prefix PH and
suffix 8-1/2 lbs. )
• Cold weather fluid option – specify “CWF”
( not available for closers with “DA” )
• Sealed closer option – specify “SC”
• Available with floor plate or threshold
installation ( floor plate shown )
• For extended offsets, consult factory
• Cast iron cement case
• Vertical door adjustment
• Standard top pivot: L180 included
• Intermediate pivot(s) required: ML19
( order separately )
• Doors 60" (1524mm) to 90" (2286mm) in
height should use one intermediate pivot. Each
additional 30" (762mm) warrants another
intermediate pivot
• For fire rated openings ( up to 3 hour assemblies )
prefix “F”. This package will be supplied with
steel top pivot (FL180) and non-hold open
closer. Furnish intermediate pivot FML19, order
separately
Note: UL listing for 1-3/4" thick doors only.
• Fire rated closers cannot have PH option
• For 20-minute labeled doors suffix “-20” to the
part number
• Furnished with wood and machine screws
• Extended spindles available in 1/2" increments
up to 2" longer than standard